Оставьте свои контакты, и мы перезвоним
Нажимая на кнопку, вы соглашаетесь с политикой конфиденциальности
Click to order
Cart
Корзина товаров
Total: 
Нажимая на кнопку, вы соглашаетесь с Политикой конфиденциальности
Erbium Doped Fiber Amplifier (EDFA)
· Optical amplifier.
· Stimulated emission.
· Fiber laser.
· Optical pumping by a diode laser.
· Characteristics of a diode laser.
· The lifetime of an excited state.
Erbium Doped Fiber Amplifiers (EDFA) are used in fiber optic transmission lines to restore the optical signal level. The advantage of erbium amplifiers is the lack of conversion into an electrical signal, the possibility of simultaneously amplifying signals with different wavelengths (which makes it possible to amplify a spectrally multiplexed signal), the exact range of erbium amplifiers corresponds to the minimum optical loss of optical fibers based on quartz glass, and a relatively low noise level and ease of incorporation into a fiber optic system. The principle of operation of EDFA amplifiers is based on the phenomenon of stimulated emission. The operation of lasers is based on the same phenomenon. In this educational set, students will get acquainted with the principles of operation and the device of fiber amplifiers. The phenomenon of stimulated emission will be studied. The lifetime of the excited state of 4I13/2 Er3+ ions will be measured. Students will also get acquainted with the basic principles of a semiconductor laser, study pulsed and continuous radiation modes, learn how to measure the dependence wavelength and power of a laser on the temperature , the total and differential slope efficiency, pulse duration and pulse repetition rate, and modulate radiation.
Components:
1) 976 nm Laser Diode Module with fiber output, 1 pc.
2) 1550 nm Laser Diode Module with fiber output, 1 pc.
3) Diode laser controller, 2 pc.
4) Aluminum Breadboard (300 mm x 450 mm x 12.7 mm, holes: M6),
1 pc.
5) Erbium-doped active optical fiber in a protective furcation tube, 1 m.
6) Photodetector with optical connector FC / APC, 5 GHz, 1 pc.
7) Fiber Optic Multiplexer 980/1550 nm, 1 pc.

8) Optical connector FC / APC, 7 pcs.
9) Optical patch cable with FC / APC connectors, 1 pc.
10) Insulator up to 300 mW, 1 pc.
11) Set for optical connector cleaning.
12) Manual, 1 pc.
13) Packing case with lodgement, 1 pc.
Optionally:
Digital Oscilloscope, 100 MHz, 2 channels, 1 pc.